| JoeCustoms.com https://docs.joecustoms.com/forums/ |
|
| Tightening 25A hip joints https://docs.joecustoms.com/forums/viewtopic.php?f=15&t=9056 |
Page 1 of 1 |
| Author: | chrysophylax [ Sat Jun 07, 2008 3:16 am ] |
| Post subject: | Tightening 25A hip joints |
It seems that everytime I disassemble 25A legs, the hips end up becoming loose despite me carefully placing the rubber friction pads back in place. Any solutions? - JM |
|
| Author: | Malcolm [ Sat Jun 07, 2008 3:42 am ] |
| Post subject: | Re: Tightening 25A hip joints |
what about usign a bit of glue froma hot glue gun, liek done with the ball joint for heads? or maybe some green stuff. |
|
| Author: | AdrienVeidt [ Sat Jun 07, 2008 4:14 am ] |
| Post subject: | Re: Tightening 25A hip joints |
Every time I take thighs apart, I glue the pad in place. Some times I put too much glue, others I put just enough. Can't say I've had any problems at all either way. |
|
| Author: | Greyryder [ Sat Jun 07, 2008 7:50 pm ] |
| Post subject: | Re: Tightening 25A hip joints |
I make a shim out of .010" thick sheet styrene, to put behind the polycap. Seems to help. |
|
| Author: | chrysophylax [ Sun Jun 08, 2008 12:27 pm ] |
| Post subject: | Re: Tightening 25A hip joints |
The drop of glue goes into the outer leg half? I'll give it a try. - JM |
|
| Author: | MacGyver [ Mon Jun 09, 2008 8:21 am ] |
| Post subject: | Re: Tightening 25A hip joints |
I put a drop of superglue on each side of the leg half, let it dry and then put em back on. I haven't had any problem with it and they get tight but not too. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|