There's a Joe Customs Wiki?
| JoeCustoms.com https://docs.joecustoms.com/forums/ |
|
| Dremel sanding accessory https://docs.joecustoms.com/forums/viewtopic.php?f=15&t=8650 |
Page 1 of 1 |
| Author: | Scramble [ Thu May 22, 2008 2:27 pm ] |
| Post subject: | Dremel sanding accessory |
I need to strip the paint and details from an ARAH Baroness torso and was looking for recommendations. I have a dremel but I'm not crazy about the sanding heads I have. Is there a gold standard everyone else uses? |
|
| Author: | pluv [ Thu May 22, 2008 2:32 pm ] |
| Post subject: | Re: Dremel sanding accessory |
Those three in the upper left are what I use for light sanding like that. I do try to see what I can get off paint wise with a nail file first though. |
|
| Author: | Scramble [ Thu May 22, 2008 2:33 pm ] |
| Post subject: | Re: Dremel sanding accessory |
There's a Joe Customs Wiki?
|
|
| Author: | J_Man [ Thu May 22, 2008 2:46 pm ] |
| Post subject: | Re: Dremel sanding accessory |
For light sanding I use one of those battery operated fingernail sanders. It doesn't turn at a high enough rate of speed to melt the plastic, and the bits designed to "datil your nails" works great to sand the tight areas and work in fine detail. |
|
| Author: | Scramble [ Thu May 22, 2008 2:54 pm ] |
| Post subject: | Re: Dremel sanding accessory |
What's one of those go for, J Man? |
|
| Author: | Mysterious Stranger [ Thu May 22, 2008 3:17 pm ] |
| Post subject: | Re: Dremel sanding accessory |
Shouldn't this be in General Customizing? |
|
| Author: | beav [ Thu May 22, 2008 3:22 pm ] |
| Post subject: | Re: Dremel sanding accessory |
Started by a mod and replied to by another yet not in the proper forum. 
|
|
| Author: | Scramble [ Thu May 22, 2008 6:29 pm ] |
| Post subject: | Re: Dremel sanding accessory |
Nothing general about this. And since we don't have a Specific Customizing subforum I... alright, I screwed up. |
|
| Author: | gijoey [ Fri May 23, 2008 12:04 am ] |
| Post subject: | Re: Dremel sanding accessory |
I like to use the large sand stone barrel for those types of jobs. Scramble are you trying to turn that torso into a female blank? If so wouldn't it be easier and less work to use a ARAH Scarlett? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|