| JoeCustoms.com https://docs.joecustoms.com/forums/ |
|
| Semi Tubular Rivets? https://docs.joecustoms.com/forums/viewtopic.php?f=15&t=7972 |
Page 1 of 1 |
| Author: | Falcone [ Fri Apr 25, 2008 6:08 pm ] |
| Post subject: | Semi Tubular Rivets? |
Has anyone found out the right size of rivet to replace ARAH arm pins? I would like to cast some arms but I would need the rivets to do so. I've searched http://www.rivetsinstock.com but don't know what I need. |
|
| Author: | roguetiger [ Fri Apr 25, 2008 9:50 pm ] |
| Post subject: | Re: Semi Tubular Rivets? |
viewtopic.php?f=15&t=2613&start=15 Check that thread. Ronin lists a place there. Another option is casting your own as mentioned in that thread as well. |
|
| Author: | nova [ Sat Apr 26, 2008 1:14 pm ] |
| Post subject: | Re: Semi Tubular Rivets? |
yeah...I think if you're going to go to the trouble of casting your own arms...you might as well cast rivits for them as well. |
|
| Author: | Falcone [ Sat Apr 26, 2008 4:03 pm ] |
| Post subject: | Re: Semi Tubular Rivets? |
I would still need an uncrimped rivet to cast though. |
|
| Author: | roguetiger [ Sat Apr 26, 2008 4:35 pm ] |
| Post subject: | Re: Semi Tubular Rivets? |
Falcone wrote: I would still need an uncrimped rivet to cast though. http://www.microfasteners.com/catalog/s ... tegory=RVL is the site with the rivets. viewtopic.php?f=15&t=2977&hilit=rivets tells you how to remove a rivet. Then you can cast it in plastic or maybe get Ronin to send you a casted one or maybe the mold for it then you can cast them yourself. |
|
| Author: | Falcone [ Mon Apr 28, 2008 1:39 am ] |
| Post subject: | Re: Semi Tubular Rivets? |
Thanks, I ordered a couple to see if they will work. They were cheap enough that if they don't work its no big deal. |
|
| Author: | Falcone [ Tue May 13, 2008 7:40 pm ] |
| Post subject: | Re: Semi Tubular Rivets? |
The rivets are the correct size, is there a clamping tool for these? I know there was a tool at rivetsnstock but I don't kow if it would be the right size. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|