| JoeCustoms.com https://docs.joecustoms.com/forums/ |
|
| keychain figures https://docs.joecustoms.com/forums/viewtopic.php?f=15&t=46678 |
Page 1 of 1 |
| Author: | night force cynic [ Tue Jun 26, 2018 4:05 pm ] |
| Post subject: | keychain figures |
The keychain figures based on the Action pilot, soldier, diver, and marine. I know most of the figure parts are the actual Joe parts except where the chains connect to... How are they held together? And can they be taken apart for customs!? |
|
| Author: | LIVEVIL [ Tue Jun 26, 2018 5:18 pm ] |
| Post subject: | Re: keychain figures |
The keychain figures are just like every ARAH figure, they are held together with an o-ring and one screw. The keychain is held through a small loop cast into the back torso of the figure. The keychain is removable and you can harvest their parts for customs. I've done it a few times in the past... |
|
| Author: | Matthew [ Tue Jun 26, 2018 8:47 pm ] |
| Post subject: | Re: keychain figures |
LIVEVIL wrote: The keychain figures are just like every ARAH figure, they are held together with an o-ring and one screw. The keychain is held through a small loop cast into the back torso of the figure. The keychain is removable and you can harvest their parts for customs. I've done it a few times in the past... Also, Some actually have the keychain attached to a peg that’s glued in the screw |
|
| Author: | night force cynic [ Wed Jun 27, 2018 9:09 am ] |
| Post subject: | Re: keychain figures |
thanks guys. that's all what I was hoping for, the keychain figures are a good bit cheaper (i.e. reasonably priced) than the actual figures. |
|
| Author: | DarkJedi [ Wed Jun 27, 2018 12:30 pm ] |
| Post subject: | Re: keychain figures |
I managed to pick up quite a few sets over the years from a KB Express, and then cleaned them out when the sets were clearance before they closed. I hooked all the chains together and that's about six foot long. Some had a backpack plug, but the majority have the little loop, as mentioned above. I planned to mod some AM/AS heads to make various Oktober Guard helmets. |
|
| Author: | HypnoHustler [ Thu Jun 28, 2018 9:24 am ] |
| Post subject: | Re: keychain figures |
I'd say the plastic quality is cheaper than the actual 30th anniversary figures, but otherwise yeah, they're the same. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|