Looking for a figure similar to this:



More or less the smae prportions with teh arms and legs, but needs to be about 4.5 or 5 inches tall. This guy would be perfect but is far too short.

Thanks

_________________

Ummm, you could lengthen the legs (cut right above the boot) and add upper arms (cut at sleeve end).

That would give you the height you need.

_________________

Ummm, you could lengthen the legs (cut right above the boot) and add upper arms (cut at sleeve end).

That would give you the height you need.

_________________

The problem is that this figure has the exact proportions of arms/legs/torso I am looking for If it was twice the height it would be perfect

_________________

reminds me of the original series thundercat badguy/henchman ,toadish.

_________________

Wait about ten years for them to make him in the 6" Black line?

_________________

Looks like it is going to be down to a full-on scratchbuild/sculpt.

_________________

http://www.industrialpolymers.com/produ ... ing-resin/ ?

_________________

Almost impossible to get in the UK. Looked into Hydroshrink a while back. Did find one firm that had it, but they don't supply it to the public. The cost of getting it shipped over from America would be prohibitive, plus customs charges and other problems with customs.

_________________

Going to try using this:



Will need a heckiva lot of filling and sanding, but the prportions are almost perfect. Will need to scratch-sculpt a head as well.

_________________

At least he's crazy poseable.

Looks like he has noticulation below the neck, yo. Go for the RevolTech figure.

_________________