JoeCustoms.com
https://docs.joecustoms.com/forums/

Removing/switching New Sculpt forarms
https://docs.joecustoms.com/forums/viewtopic.php?f=15&t=11642		 Page 1 of 1
Author:  kingofpain26 [ Sun Sep 28, 2008 8:38 am ]
Post subject:  Removing/switching New Sculpt forarms
could anyone enlighten me on how to swap out the forearms for Valor Vs venom new sculpt figures?
Author:  Kilcarr [ Sun Sep 28, 2008 10:01 am ]
Post subject:  Re: Removing/switching New Sculpt forarms
Boil N Pop always works for me.

Basically, I grab a pan, fill it with water, and toss the parts in that I wanna swap. Turn up the heat and then mind the parts so they don't touch the sides of the pans. You want to wait until tiny bubbles form all over the parts and when the water starts to boil just a little pull them out.

Be careful, as the parts will sometimes have this hot water inside of them. Also, they cool quickly so just suck it up, schoolgirl. :-P

Anyhoo, it's simply a matter of applying pressure from there, boss.
Author:  Keenan [ Sun Sep 28, 2008 10:23 am ]
Post subject:  Re: Removing/switching New Sculpt forarms
As an add on to what Billy said, just put a cup of water in the old nuker- usually about a minute and a half gets it hot enough, then drop your parts in.
Author:  kingofpain26 [ Sun Sep 28, 2008 11:02 am ]
Post subject:  Re: Removing/switching New Sculpt forarms
COOl, Thanks!

bought about 40 of those Family Dollar VvV single packs,.. gonna make an entire squadron of Fighter pilots and black ops soldiers out of Aces, Snake Eyes, Baronesses, Heavy Dutys and Stalkers
Author:  Greyryder [ Sun Sep 28, 2008 5:49 pm ]
Post subject:  Re: Removing/switching New Sculpt forarms
I just use scalding hot water, out of the tap.
Author:  ThMick [ Sat Oct 04, 2008 5:50 pm ]
Post subject:  Re: Removing/switching New Sculpt forarms
JFAK075 wrote:
As an add on to what Billy said, just put a cup of water in the old nuker- usually about a minute and a half gets it hot enough, then drop your parts in.


Be careful when you drop them in though, because depending on the vessel you are using, dropping in the parts may caused the water to erupt into boilng, which may scald you if your hand is in the wrong place.

Also: http://wiki.joecustoms.com/wiki/Lower_Arm_Swapping
Author:  alleyviperelite [ Sat Oct 04, 2008 11:21 pm ]
Post subject:  Re: Removing/switching New Sculpt forarms
A hair dryer works too and doesn't make as much mess. And on a disgusting note; your mouth should be 98.6 degrees F, that's hot enough to soften the plastic to remove the pin that goes through the forearm and the swivel.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/