| JoeCustoms.com https://docs.joecustoms.com/forums/ |
|
| Skull Buster & Pounce https://docs.joecustoms.com/forums/viewtopic.php?f=14&t=47690 |
Page 1 of 1 |
| Author: | past nastification [ Wed Apr 08, 2020 4:27 pm ] | ||||
| Post subject: | Skull Buster & Pounce | ||||
My take on the Range Vipers' leader and his pet fox.
|
|||||
| Author: | past nastification [ Wed Apr 08, 2020 4:28 pm ] | ||||
| Post subject: | Re: Skull Buster & Pounce | ||||
more images the bunnies didn't make it to the finished stage. They've been set aside for another figure.
|
|||||
| Author: | 2DARK2C [ Wed Apr 08, 2020 5:56 pm ] |
| Post subject: | Re: Skull Buster & Pounce |
lots of great details. the unmasked head paint job is great. if you kept the bunnies for easter the grenade launcher could lop easter eggs  I think you could use some heatshrink for a neck cuff with the helmet to get rid of the thin looking neck. some of your tape work would get it too. I might add some of the tattered looking cape on into a skirt as well to help cover the square t crotch/flat butt. |
|
| Author: | sgcaper [ Thu Apr 09, 2020 8:17 pm ] |
| Post subject: | Re: Skull Buster & Pounce |
Very cool. |
|
| Author: | past nastification [ Fri Apr 10, 2020 10:43 pm ] |
| Post subject: | Re: Skull Buster & Pounce |
Thanks, guys. I put a lot of work into this one, but it's just not landing. You make some good points, 2DARK2C. The neck is too thin. Instead of using a cast one, I tried to use a thinner Star Wars one cut from a Clone Wars Annakin. It might have worked on a female figure, but not on most male figures. The t-crotch/butt don't bother me too much because that's the format. But I should have camouflaged the butt's flatness more than I did. Does anyone know what the human head is? It's from starwarsgeek, but I'm not sure what it is. Maybe a Steve Rogers? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|