I got an idea for upgrading my POC Cobra Fury with the turret from the Whirlwind but I'm not sure if the two pieces are compatible. Was wondering if anyone can do a dry fit test for me.

_________________

Based on a measurement, I'd say "No". If you're planning what I think you have in mind, the turret hole on the Fury looks to be around 1/4" in diameter. The turret hole on the Whirlwind is more like 3/8". You would have to widen the turret hole on the Fury to accommodate the Whirlwind weaponry, and I'm not sure there's enough plastic there to do that.

The connection isn't an issue. I can make that work. I'm more concerned with the diameter of the base of the Whirlwind matching up with the turret base on the Rage/Fury.

_________________

Yes. A whirlwind Turret will sit on a rage turret with a little bit of extra space

The issue you will run into is both the rage turret base and whirlwind turret have a male connector

_________________

Thanks nova! The connectors isn't an issue as I'll be customizing the whole vehicle so cutting up the base or Whirlwind isn't a problem.

_________________